Alpha 360 Co. LTd 200801 用户手册
operating instructions of Alpha 360 z-Stick
Operating instructions:
The Z-Stick operates in three distinct modes: Inclusion-Mode, Removal-Mode and SerialAPI-
Mode. Both Inclusion-Mode and Removal-Mode require the Z-Stick to be unplugged from the
USB connector of the host, while SerialAPI-Mode requires the Z-Stick to be plugged into the
USB connector of the host.
Inclusion-Mode:
1. To initiate Inclusion-Mode, unplug the Z-Stick from the USB connector and then tap the
button. (The LED will blink slowly.)
Note: While in Inclusion-Mode, the Z-Stick is in perpetual inclusion. There is no need to
press the button on the Z-Stick again to include each new device.
2. To include a new Z-Wave device into the network, simply go to the device with the Z-
Stick and press the button on the device you wish to include. (The LED on the Z-Stick
will blink fast during a network neighbor discovery and stay solid for 3 seconds to
indicate successful inclusion of the device into the network.)
3. The LED will then return to blinking slowly, indicating readiness for further device
inclusions. Repeat step 2 for each device as you wish to include.
4. Tap the Z-Stick button to turn it off.
Removal-Mode:
1. To initiate Removal-Mode, unplug the Z-Stick from the USB connector. Then press
and
hold down the button for approximately 3 seconds. (The LED will transition from
blinking slowly to blinking fast.)
Note: While in Removal-Mode, the Z-Stick is in perpetual removal. There is no need to
press the button on the Z-Stick again to remove each device.
2. To remove a Z-Wave device from the network, simply go to the device with the Z-Stick
and press the button on the device you wish to remove. (The LED on the Z-Stick will
immediately stay solid for 3 seconds to indicate successful removal from the network.)
3. The LED will then return to blinking fast, indicating readiness for further device
removals. Repeat step 2 for each device as you wish to remove.
4. Tap the Z-Stick button to turn off.
SerialAPI-Mode:
1. To initiate SerialAPI-Mode, plug the Z-Stick into the USB connector of the host.
Note: While in SerialAPI-mode, the Z-Stick acts as a Z-Wave adapter and responds to
commands sent through USB by the host processor software. Pressing the Z-Stick
button will not have any effect while in SerialAPI-Mode.