RSI VIDEOTECHNOLOGIES SE00 用户手册
www.videofied.com
Mounting
>
>
Use proper tools and hardware.
>
Mount where siren can be heard by occupants.
>
Mount out-of-reach of intruders to help prevent
disabling of unit.
1
Remove batteries.
2
Hold unit up
against mounting
surface and mark
the three mounting
holes.
3
Drill pilot holes
and install anchors
where needed.
4
Place unit on mounting surface so mounting holes
line up with pilot holes/anchors and secure unit with
appropriate screws.
5
Install batteries, observing correct polarity.
6
Attach front cover.
Electrical Data
Panel Compatibility
XL, Visio, XT, XTIP
Power requirements
Four 1.5 V Alkaline Batteries
Nominal Voltage
6V
Low Battery Limit
4.2V
Battery type
Energizer Alkaline LR20, D size
Battery life
Up to 4 years
RF technology
S
2
View
®
Radio type
Spread Spectrum Bidirectional
Operating frequency
915 MHz
Transmission security
AES encryption algorithm
Supervision
Polled signal every 8 minutes
Antenna Integrated
Tamper detection
Wall and cover tampered
Speaker impedance
4 ohms
Output level
110 dB @ 1 meter
Output duration
Configured in Control Panel
Built-in sounder
Emits entry/exit delay beeps, alarms
Operating temperature
-10°/+40°C (14°/104°F)
Maximum relative humidity
70%, non-condensing
Approvals
FCC Part 15C
Physical Data
Material ABS—ULV0
Dimensions (LxWxD)
280 mm x 158 mm x 57 mm
11 in. x 6-1/4 in. x 2-1/4 in.
Weight
740 g/26 oz.(without batteries)
Installation/Mounting
Siren/Base
Two screws secure siren to base; three screws
secure siren base to mounting surface.
Mounting Holes
Indoor Siren SE601
I N S T A L L A T I O N D A T A S H E E T