Ingenico IWL2XXBCL 用户手册
iWL2xx Wireless Series
•
13/32
Copyright © 2011 Ingen ico
900003061 R11 000 04/1050
All rights reserved
4.4.
Paper roll
4.4.1.
Mains characteristics of INGENICO paper roll
Depending on iWL model two paper roll can be used:
R40 paper roll Characteristics
R40 paper roll Characteristics
Precisions
Colour
White
Width
58 mm
Diameter
40 mm
Length
About 18 metres
R25 paper roll Characteristics
Precisions
Colour
White
Width
58 mm
Diameter
25 mm
Length
About 9 metres
•
The thermal paper can be deteriorated by poor storage conditions, so we
recommend you to avoid :
recommend you to avoid :
–
storage in hot wet places (near air-conditioner, humidity higher than 85%)
–
exposure to sunlight or ultraviolet for long periods
–
contact with organic solvents (solvent type adhesive)
–
direct contact with materials containing plasticizers (PVC transparent
folders or envelopes)
folders or envelopes)
–
direct contact with «diazo» papers
–
direct contact with water
–
Rubbing or pressing the paper too strongly
•
Recommended paper:
AF50KS (Jujo), or F5041 (Mitsubishi), or TK50KS (Nippon_Paper), or equivalent.
WARNING
For best product performance, only use heat sensitized paper approved by Ingenico.
WARNING
Switch off the terminal prior to installing a paper roll.
Use only paper approved by Ingenico.
The use of non approved paper is likely to damage the printer of your terminal.
For best product performance, only use heat sensitized paper approved by Ingenico.
WARNING
Switch off the terminal prior to installing a paper roll.
Use only paper approved by Ingenico.
The use of non approved paper is likely to damage the printer of your terminal.
iWL2xx Wireless Series
•
14/32
Copyright © 2011 Ingen ico
900003061 R11 000 04/1050
All rights reserved
4.4.2.
Installing paper roll
•
Open the paper compartment by lifting the catch located at the rear of the iWL2XX and
pull the cover to the rear of the terminal.
pull the cover to the rear of the terminal.
•
Insert the paper roll in the compartment following the directions shown on the below
picture
picture
•
Pull the paper up to the top of the terminal
•
Maintain the paper and close the cover
•
Press simultaneously on both upper corners of the paper flap, as shown by red arrows
on picture, until it clips into position
on picture, until it clips into position
ADVICE
If you insert a new R40 paper roll, tear off the first length (one complete turn to avoid
printing on adhesive tape footprint). This is not necessary on R25 paper roll as it has no
tape.