Mobotix KPADC 用户手册
MX-KeypadC-EXT KeypadRFID
Regulatory Notice
31.287-004_U
S_06/2018
Federal Communications Commission (FCC) and Industry Canada (IC)
Notice for MX-KeypadC-EXT (PMN: KeypadRFID)
(FCC ID: YYRKPADC, IC ID: 9357A-KPADC)
NOTICE:
This device complies with Part 15 of the FCC Rules [and with RSS-210 of Industry Canada]. Operation is
subject to the following two conditions:
subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired
operation.
NOTICE:
Le présent appareil est conforme aux CNR d‘Industrie Canada applicables aux appareils radio exempts
de licence. L‘exploitation est autorisée aux deux conditions suivantes:
de licence. L‘exploitation est autorisée aux deux conditions suivantes:
3. l‘appareil ne doit pas produire de brouillage, et
4. l‘utilisateur de l‘appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d‘en compromettre le fonctionnement.
NOTICE:
Changes or modifications made to this equipment not expressly approved by MOBOTIX AG may void the
FCC authorization to operate this equipment.
FCC authorization to operate this equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Radiofrequency Radiation Exposure Information:
The radiated output power of the device is far below the FCC radio frequency exposure limits. Never-
theless, the device shall be used in such a manner that the potential for human contact during normal
operation is minimized.
theless, the device shall be used in such a manner that the potential for human contact during normal
operation is minimized.
Ministry of Internal Affairs and Communications Notice for MX-KeypadC-EXT
NOTICE:
• This device has been granted a designation number by Ministry of Internal Affairs and Communications
• This device should not be modified (otherwise the granted designation number will be invalid)
• This device should not be modified (otherwise the granted designation number will be invalid)
Accessories
MX-AdminCard1
MX-UserCard1