MitraStar Technology Corporation DSL2401HNAT1CC 用户手册

Chapter 5    Wireless 5GHz

48

The station monitor displays the connection status of the wireless clients connected to (or trying to 

connect to) the Router. To open the station monitor, click Network Setting > Wireless 5GHz > 

Station Information. The screen appears as shown.

Figure 30 Network Setting > Wireless 5GHz > Station Information 

DTIM Interval

Delivery Traffic Indication Message (DTIM) is the time period after which broadcast and 

multicast packets are transmitted to mobile clients in the Power Saving mode. A high 

DTIM value can cause clients to lose connectivity with
the network. This value can be set from 1 to 100.

Beamforming

Select this option to have the Router focus the wireless signal and aim it directly at the 

wireless clients. Clear this option to disable beamforming. You may need to do this if 

beamforming causes issues with IEEE 802.11 N, G, or B devices.

Short GI

Select this option to set the Router to use a reduced guard interval. This increases 

throughput at the cost of an increased error rate in certain network environments with 

greater radio interference.

SCS

Select this to have the Router automatically determine and select the most suitable 

wireless channel.

QHop

Enable DFS 

Channels

Select this to use Dynamic Frequency Selection to share wireless spectrum with radar 

systems.  The field to the right displays the channel the Router uses for 5 GHz wireless 

after DFS channels are disabled. 

Seamless DFS

Table 21   Network Setting > Wireless 5GHz > Advanced (continued)

Table 22   Network Setting > Wireless 5GHz > Station Information

SSID

Select the wireless network for which to display connection status information for the 

connected wireless clients.

#

This displays the number of the device in the list of connected wireless clients.