Reconyx Inc. HF-TRX 用户手册
9
©RECONYX, Inc.
Secure Digital
®
(SD or SDHC) Card Specifications
A Secure Digital (SD/SDHC) card is used to store the pictures your camera
captures. These images may be transferred to your computer using standard
image viewing software or RECONYX™ MapView™ or BuckView™
mapping and image management software.
captures. These images may be transferred to your computer using standard
image viewing software or RECONYX™ MapView™ or BuckView™
mapping and image management software.
TIP: Many digital cameras, GPS units, and cell phones can be used to view
images taken by your HyperFire™ camera. No need to purchase a special
purpose viewer!
images taken by your HyperFire™ camera. No need to purchase a special
purpose viewer!
Inserting and Removing the memory card
Make sure the orientation is correct and that the card is aligned properly.
Push gently on the memory card as shown below until it clicks into
place.
Push gently on the memory card as shown below until it clicks into
place.
Warning: Inserting the memory card upside down or backwards could
damage the camera or the memory card. Damage resulting from
inserting the card incorrectly is not covered under warranty.
damage the camera or the memory card. Damage resulting from
inserting the card incorrectly is not covered under warranty.
To remove memory cards:
1. Press <OK> to disarm the camera (the battery status and number of
pictures taken since last armed will be displayed on the LCD).
2. Switch the power OFF.
3. Press and release the card to partially eject the memory card.
4. The card can then be removed by grasping it with your fingers.
3. Press and release the card to partially eject the memory card.
4. The card can then be removed by grasping it with your fingers.
NOTE: Always disarm the camera (by pressing OK) and switch the power off
before removing or inserting the memory card.
before removing or inserting the memory card.