Reconyx Inc. HF-TRX 用户手册
www.reconyx.com
14
Level 1: Main Menu Items
NOTE: Main Menu Items are shown in Yellow on the Programming
Diagram (Page 13).
Arm Camera – When you select this option, your camera arms in ten
seconds, unless you cancel it before the countdown is complete by pressing
the “OK” button.
WalkTest – When you select this option, your camera flashes an indicator
light so that you can test its aim by walking in front of it. The WalkTest mode
shows you exactly where the camera’s active motion detection zones are
located. The tilt of the camera is critical, as slight changes are magnified at
greater distances from the camera.
seconds, unless you cancel it before the countdown is complete by pressing
the “OK” button.
WalkTest – When you select this option, your camera flashes an indicator
light so that you can test its aim by walking in front of it. The WalkTest mode
shows you exactly where the camera’s active motion detection zones are
located. The tilt of the camera is critical, as slight changes are magnified at
greater distances from the camera.
TIP: If left in WalkTest mode, the camera will automatically arm itself after 2
minutes with no motion events. This allows you to set the camera up, check
its aim using WalkTest, and then just walk away.
minutes with no motion events. This allows you to set the camera up, check
its aim using WalkTest, and then just walk away.
Erase Card – When you select this option, your camera wipes your entire
memory card clean, removing all images and other information from the
card. You should not select Erase Card unless you are absolutely certain
you want to remove everything from the card.
Check Status – When you select this option, your camera displays the
number of pictures it has taken, the amount of space used on your memory
card, and the amount of battery power remaining.
NOTE: The battery status shows the level for different types of batteries. If
memory card clean, removing all images and other information from the
card. You should not select Erase Card unless you are absolutely certain
you want to remove everything from the card.
Check Status – When you select this option, your camera displays the
number of pictures it has taken, the amount of space used on your memory
card, and the amount of battery power remaining.
NOTE: The battery status shows the level for different types of batteries. If
you change battery types be sure to change the “Battery Type” setting.
Change Setup – Allows you to change the way your camera functions.
Battery Type – Allows you to select what type of batteries you are using to
accurately display the amount of power remaining.
Camera Info – When you select this option, your camera displays its
firmware version number (V) and serial number (S). You may need this
information when contacting RECONYX™ with questions about your
camera.
NOTE: Professional Series cameras have many additional settings that can
Battery Type – Allows you to select what type of batteries you are using to
accurately display the amount of power remaining.
Camera Info – When you select this option, your camera displays its
firmware version number (V) and serial number (S). You may need this
information when contacting RECONYX™ with questions about your
camera.
NOTE: Professional Series cameras have many additional settings that can
be programmed using the Configuration Software on your PC,
included with MapView™ Professional Software (see additional notes
below).
included with MapView™ Professional Software (see additional notes
below).