Metrics Technology Inc. DBA CasaWorks 072004 用户手册
Controlling lights
When you click the “Lights” button, the screen presented allows you to control any
light on the system.
When you click the “Lights” button, the screen presented allows you to control any
light on the system.
1. From the list labeled “Choose a room”, select the room where the light is located.
2. From the list marked “Choose a light”, select the light you wish to control.
3. Use one of the following to control that light:
4. Click “On” or “Off” to turn the light fully on or off.
5. Drag the slider control up or down to set the light to the desired level.
6. Type a number from 0 to 100 in the field next to the slider
2. From the list marked “Choose a light”, select the light you wish to control.
3. Use one of the following to control that light:
4. Click “On” or “Off” to turn the light fully on or off.
5. Drag the slider control up or down to set the light to the desired level.
6. Type a number from 0 to 100 in the field next to the slider
0 = fully off
100 = fully on
Any number between 0 and 100 is a dim level
100 = fully on
Any number between 0 and 100 is a dim level
Removing a lamp module
If you wish to re-assign a lamp module to a different location, it must first be removed
from the system. The following steps will guide you through the process.
1. Click the “Lights” button on the left side of the screen.
2. At the bottom of the screen, click the “Remove a Light” button.
3. Click the “Remove button.
4. Go to the lamp module that you want to remove and press the button on it.
5. The screen should now say “Lamp module successfully removed”.
2. At the bottom of the screen, click the “Remove a Light” button.
3. Click the “Remove button.
4. Go to the lamp module that you want to remove and press the button on it.
5. The screen should now say “Lamp module successfully removed”.
If not, press the button again until this happens.
6. If you wish to remove another lamp module, click the “Remove another light”
button.
Otherwise, click “Finished”.
Otherwise, click “Finished”.