Therm-O-Disc Inc 52WM 用户手册
52WM-3T
Therm-O-Disc, Inc.
1320 South Main Street
Mansfield, OH 44907
(419)-525-8500
www.thermodisc.com
Mansfield, OH 44907
(419)-525-8500
www.thermodisc.com
Quick Start Guide
Configuring Wireless Modules
1. Verify that the Emerson Smart Wireless Gateway is
turned on. Refer to the “Wireless System Startup
Guide” for additional information.
2. Turn on the Wireless Module by pressing and holding
the Config button B1 until LEDs L1 and L2 light up mo-
mentarily.
3. Wireless Modules are shipped with a factory default Net-
ID and Join Key already programmed. The factory default
NetID and Join Key are listed below:
NetID: 1229
Join Key: 445553544e4554574f524b53524f434b
4. If the NetID and Join Key of the Wireless Module and
Smart Wireless Gateway do not match, reprogram the
Wireless Module to match the NetID and Join Key of the
Smart Wireless Gateway. Refer to the “Wireless System
Startup Guide” for additional information.
Installing Wireless Modules
Attach the Sensor String to the inside middle of the rack door.
Start 6” from the bottom and work up. Refer to the “Wireless
System Startup Guide” for additional information.
1. Use at least one cable fastener to secure each sense point
on the Sensor String Multiple cable ties may be used to
secure the sense points both above and below the Sensor
housings.
2. Keep cable straight and tight while securing Sensors.
3. Trim excess cable tie material and discard.