RDI Technology Co. Ltd. CA630B 用户手册
2
Wireless Receiver
1. Receiver Antenna – receives signals from the camera(s). Adjust the antenna to vertical position for
better signal reception.
better signal reception.
2. DC 9V Power Input – Connect the
included DC 9V power adaptor to power
the receiver.
included DC 9V power adaptor to power
the receiver.
3. A/V Out Port – Connect the included
A/V cable to view video on a TV or
monitor, or record to a VCR/DVR.
A/V cable to view video on a TV or
monitor, or record to a VCR/DVR.
4. Alarm Volume Knob – Turn the knob
to increase or decrease the volume of
the audio alarm.
to increase or decrease the volume of
the audio alarm.
5. Indication LEDs – Indicates the
status of the system. There are 6
indication LEDs:
status of the system. There are 6
indication LEDs:
MANUAL: Indicates manual switching
mode between activated cameras.
mode between activated cameras.
AUTO: Indicates automatic switching
mode between activated cameras.
mode between activated cameras.
M: Indicates manual recording mode.
A: Indicates auto recording mode. In this
mode receiver starts to record when there is motion detection in camera side.
mode receiver starts to record when there is motion detection in camera side.
NEW: Indicates new recorded video.
FULL: Indicates that the SD card is full of memory. It is only available when Overwrite is disabled.
6. Operation Buttons – Use these buttons for receiver operation.
(Channel) M – Press the button to manually switch between all activated cameras. Once the button is
pressed, the indication LED MANUAL will be on.
pressed, the indication LED MANUAL will be on.
(Channel) A – Press the button to view cameras in automatic switching mode. Once the button is
pressed, the indication LED AUTO will be on.
pressed, the indication LED AUTO will be on.
(Record) M – Press the button to start recording, press it again to stop recording. In this manual
recording mode, the indication LED M will be on.
recording mode, the indication LED M will be on.
(Record) A – Press the button to switch the system to automatic recording mode. In auto recording
mode, the indication LED A will be on and the receiver starts recording when motion detected by a
camera. The recording time can be set to 15s or 30s. Press the button again to cancel automatic
recording.
mode, the indication LED A will be on and the receiver starts recording when motion detected by a
camera. The recording time can be set to 15s or 30s. Press the button again to cancel automatic
recording.
Quad – Press Quad button to view the images in quad mode. Press Quad or (Channel) A buttons to
exit from quad mode to automatic switching mode, press (Channel) M button to exit from quad to
manual switching mode.
exit from quad mode to automatic switching mode, press (Channel) M button to exit from quad to
manual switching mode.