RDI Technology Co. Ltd. RX230 用户手册

 

 
 

 

9

 
1. AUTO BUTTON – When the receiver is set to AUTO Mode, it will continuously switch between 
connected cameras. The dwell time is set to 4 seconds per camera (by default), however this can be 
adjusted to 2~30 seconds.  
 

•  LW1001/ LW1002/ LW1010 /LW1012: To adjust the dwell time, press 

and hold both the AUTO and MANUAL buttons at the same time – this 
will produce beeps indicating one second increments. Once the 
desired dwell time has been reached, release the buttons. 

•  LW1020/LW1022: To adjust the dwell time, press and hold both the 

AUTO and MANUAL buttons at the same time. Hold both buttons 

pressed for the amount of time the dwell time needs to be set to. 

Once the desired dwell time is reached, release both buttons and the 
indicator light on the receiver will show the dwell time by blinking 1 

time for each second of dwell time 

 

 
 
 
2. MANUAL BUTTON – Press the MANUAL button to switch between 
available cameras manually. The Receiver will switch to a different camera (if 
available and configured) each time the MANUAL button is pressed. 

Installing the wireless receiver (for LW1001, LW1002, LW1010, LW1012, LW1020, and LW1022) 
For connecting to a TV/monitor <OR> recording on a VCR/DVD recorder. 
 

1.  Connect the AV Cable to the back of the receiver. Connect the other end of the Cable to the 

Video IN (Yellow) and Audio IN (White) ports on the TV, VCR or other viewing/recording devices 
with RCA inputs. 

2.  Plug the Receiver power cable into the 9V POWER input (5V for LW1020/LW1022). Plug the 

power cable into a wall outlet. 

3.  Place the receiver in a place that will have clear reception to your camera(s). Try to avoid placing 

the receiver near other 900MHz devices (such as older cordless phones, wireless headphones, 
etc.).  

 

NOTE: Do not force the antennas past their locked positions, or damage may occur to the 
Receiver or Camera. 

 
Installing the wireless receiver (for LW1020 and LW1022 ONLY) 
For viewing on your PC <OR> remotely through a web browser. 
 

4.  Connect one end of the USB Cable into the Receiver and the other end into a computer. Please 

refer to the Quick Start Guide to install the driver and Yoics. For additional Yoics information or 
advanced Yoics user options, Please visit the              website at 

www.yoics.com