MTI Co. Ltd. RF25-MWM101 用户手册
BDA Installation and Operating Guide
Version 1.0 17
3.1.2 Connection of electrical power cable
Figure 15 Assembly of electrical power cable of the BDA
Figure 16 Electrical power cable connection of the BDA
z
Ensure that AC input power is in the range of the specification (typical AC 110V,
range: AC 90V ~ AC 120V).
z
Connect the power cable to the power connector on the bottom panel of the
BDA and then check if ‘Power’ LED on the front of the BDA is green and ‘RUN’
LED is blinking.
LED is blinking.
z
Connect a Laptop PC to the BDA and execute the Operating Software (GUI).
z
Minimize Gain value in the down and up link on the Operating Software of
the Laptop PC to protect the FWD HPA & FWD Transceiver of the BDA.
z
Check if VSWR of Link antenna is within the range of specification.(Less than
1.38, equal to 16dB of Return Loss)
z
If the VSWR of Link antenna is not good, check antenna connection status and
cable.