Racom RIPEX-154 用户手册
Note: There is not a possibility to set the Broadcast address, since ITT
Flygt broadcast messages always have the address 0xFFFF. Hence when
the Broadcast is On, packets with this destination are handled as broad-
casts.
Flygt broadcast messages always have the address 0xFFFF. Hence when
the Broadcast is On, packets with this destination are handled as broad-
casts.
•
First Slave Address
Default = 1
Slave addresses are not defined in the ITT Flygt protocol. However
Slave addresses have to be defined in the RipEX network. This is the
First Slave address in decimal format.
Default = 1
Slave addresses are not defined in the ITT Flygt protocol. However
Slave addresses have to be defined in the RipEX network. This is the
First Slave address in decimal format.
•
Number of Slaves
Default = 1
Since the ITT Flygt protocol Master (centre) polls the Slaves (remotes)
one by one without any addressing, number of slaves has to be defined.
Default = 1
Since the ITT Flygt protocol Master (centre) polls the Slaves (remotes)
one by one without any addressing, number of slaves has to be defined.
•
Wait timeout [ms]
Default = 5000
An ITT Flygt Slave sometimes sends the WAIT COMMAND (0x13) to its Master. The RipEX does
not accept the next WAIT COMMAND (discards it), till the Wait timeout does not expire. The Re-
commended value is in the 1-10 seconds range.
Default = 5000
An ITT Flygt Slave sometimes sends the WAIT COMMAND (0x13) to its Master. The RipEX does
not accept the next WAIT COMMAND (discards it), till the Wait timeout does not expire. The Re-
commended value is in the 1-10 seconds range.
Modbus
Modbus RTU is a serial polling-type communication protocol used by Master-Slave application.
When RipEX radio network run in Router mode, more Modbus Masters can be used within one Radio
network and one Slave can be polled by more Masters.
Modbus protocol configuration uses all parameters described in Common parameters.
When RipEX radio network run in Router mode, more Modbus Masters can be used within one Radio
network and one Slave can be polled by more Masters.
Modbus protocol configuration uses all parameters described in Common parameters.
Profibus
RipEX supports Profibus DP (Process Field Bus, Decentralized Periphery) the widest-spread version
of Profibus. The Profibus protocol configuration uses all parameters described in
Common parameters.
of Profibus. The Profibus protocol configuration uses all parameters described in
Common parameters.
99
© RACOM s.r.o. – RipEX Radio modem & Router
Advanced Configuration