ENUSTECH BHF500 用户手册
The product uses an advanced lithium polymer rechargeable battery. It is important that
you charge the product for 2 hours the first time you use it, to ensure the battery is
fully charged ready for use and for best performance.
1) How to charge
Connect the product to the USB charger cable to the vehicle charger. Plug the
vehicle charger into your car’s power outlet. The light on the USB charger cable will
light up red while it is charging. When the light on the USB charger cable turns
green, this indicates that the product is fully charged.
Note:
When the battery of the product is low, the battery icon on the product will blink,
indicating that it needs to be charged again.
3. Pairing
Before you use the product you must first pair it with your mobile phone.
Note: you can only pair devices that are Bluetooth enabled. To see if you mobile phone
is Bluetooth enabled. Check your mobile phone’s user guide.
1) If product is powered on, turn off the product.
2) Press the Multi-function button for 7 sec. Release the button when Bluetooth
status icon on the product begins to flash quickly with beep sound (or TTS
Message:
Pairing succeeded).
3) Find the product (BHF-500) by using device find function on the mobile phone.
4) Enter the passkey 0000 on your mobile phone.
5) When the product is successfully paired, you will see a change of Bluetooth
status icon or hear the message or tone that it is paired with your mobile
phone.
Note: If both devices do not pair within 2 minute, the product will go into stand
by mode and you will need to initiate re-pairing by repeating steps 1 to 4.
4. Using the product
1) Turning the product On/Off
Power On: Push the multi-function button of the product for 2 seconds to turn it