Impinj Inc. XARRAY 用户手册
Speedway Revolution Installation and Operations Guide Octane 4.11
Chapter 3: Configuring and Monitoring
Chapter 3: Configuring and Monitoring
20
Revision 4.11 Copyright ©2014, Impinj, Inc.
You can determine the name and the IP address via the RShell show network
summary command.
Note
: The show network summary command provides the dynamic values returned by
DHCP or LLA if the current configuration is dynamic. The local hostname resolution feature
(mDNS) gives the reader a local hostname in addition to an IP address as its network
identity. On an isolated network that lacks DNS service but has mDNS enabled, a Reader
with hostname speedwayr-00-01-02, for example, may be reached using
speedwayr-00-01-02.local.
(mDNS) gives the reader a local hostname in addition to an IP address as its network
identity. On an isolated network that lacks DNS service but has mDNS enabled, a Reader
with hostname speedwayr-00-01-02, for example, may be reached using
speedwayr-00-01-02.local.
4. In Model, select the appropriate Speedway Revolution model (either Speedway R220
or Speedway R420). If you want MultiReader to issue a warning if it detects a model
other than what is configured, confirm Warn on the model mismatch checkbox is
selected. (Model mismatch is selected by default.)
other than what is configured, confirm Warn on the model mismatch checkbox is
selected. (Model mismatch is selected by default.)
5. If the Antenna Hub feature is enabled on the Reader, be sure to set Antenna Hub
Enabled to Yes.
Note
: The Antenna Hub feature is only available on the Speedway Revolution R420. The
show anthub summary
command indicates if the Antenna Hub has been enabled on the
Speedway Revolution. For MultiReader to work correctly, the feature status on the
Speedway Revolution must match
Speedway Revolution must match
6. Configure the key RF parameters described below:
7. Under Reader 1, on the left side of the Reader Settings dialog box, select Modes, RF,
7. Under Reader 1, on the left side of the Reader Settings dialog box, select Modes, RF,
and Power. The following screen displays: