Impinj Inc. XARRAY 用户手册
Speedway Revolution Installation and Operations Guide Octane 4.11
Chapter 3: Configuring and Monitoring
Revision 4.11 Copyright © 2014, Impinj, Inc.
23
Figure 3.5 MultiReader Tag Inventory Display
In this case, the Reader detected five tags. Because the search mode is Dual
Target, the Reader continuously reads the tags, first reading the A flags, and then
reading the B flags. Notice in the image above that one of the tag entries is a pinkish
color. The tag entry changes to red when a tag is not actively read. For example, if
you change the Search Mode to Single Target with Suppression, the Reader
reads each tag only once. All five entries would quickly turn red and stay red as
shown below.
Target, the Reader continuously reads the tags, first reading the A flags, and then
reading the B flags. Notice in the image above that one of the tag entries is a pinkish
color. The tag entry changes to red when a tag is not actively read. For example, if
you change the Search Mode to Single Target with Suppression, the Reader
reads each tag only once. All five entries would quickly turn red and stay red as
shown below.
Figure 3.6 MultiReader Tag Inventory Aging Display
If you see tag data appearing in MultiReader, your Reader is most likely installed
correctly and the antennas are functioning properly. If you do not see all the tags
you placed in the read-zone, try moving the tags to a slightly different location or
orientation.
correctly and the antennas are functioning properly. If you do not see all the tags
you placed in the read-zone, try moving the tags to a slightly different location or
orientation.
15. Select STOP Inventory Run to stop the tag inventory process.
Monitoring Speedway Revolution
Use RShell to monitor the Reader health and performance when Speedway Revolution is up
and running. This section presents the primary RShell commands for viewing the network
and RFID statistics, plus the Reader logs. For details about these commands, see the RShell
Reference Manual.
Speedway Revolution also supports industry standard SNMP, with MIB2 and EPCglobal
Reader Management MIB. For more information, see the Octane SNMP Guide.
and running. This section presents the primary RShell commands for viewing the network
and RFID statistics, plus the Reader logs. For details about these commands, see the RShell
Reference Manual.
Speedway Revolution also supports industry standard SNMP, with MIB2 and EPCglobal
Reader Management MIB. For more information, see the Octane SNMP Guide.
Viewing Network Parameters and Statistics
Use the RShell show network command to display networking parameters and
statistics. Using this command with the indicated parameters, you can view the
following information:
statistics. Using this command with the indicated parameters, you can view the
following information: