Outsite Networks Inc. APX-2012 用户手册
AllPoints Keypad Installation Manual
Page 11
11.2.2.
Configure the Unit Mode
The AllPoints Keypad printer operates in one of two available Unit Modes; Server or
Remote.
The Server mode allows the AP Keypad to connect to the Internet and act as an internet
access server for other AP Keypad units which operate as Remote units.
AP Keypad units operating in the Remote mode do not connect directly to the Internet
and must connect to an AP Keypad operating in the Server Mode.
Only one AP Keypad unit should be configured to operate in the Server mode per site.
That unit will be referred to in this manual as the AP Keypad Server.
The Unit Mode values are:
Server Mode = “1”
Remote Mode = “2”
After entering the Configuration Mode, set the Unit Mode item value, pressing the “2”
key followed by the “2” key again. And then follow the printed directions.
11.2.3.
Configure the Unit ID number
Configuration of the AP Keypad requires setting the printer’s Unit ID #. The AP Keypad
server unit must always be configured as Unit ID number “1”.
If more than one AP Keypad unit is installed at the site, the additional units must be
installed as Unit ID number “2” and up.
To set the Unit ID item, press 2/3 or the “2” Key followed by the “3” key and then follow
the printed directions.
Note: By default setting the Unit Mode to “1” will set the Unit ID number to “1”.
Setting the Unit Mode to “2” will set the Unit ID to “2”. If more than one AP Keypad
unit is set to the Remote Mode then the Unit ID must be manually incremented. For
example, if there are 3 AP Keypad units at a site, the 2nd AP Keypad set to Unit Mode
“2” would need to be set to Unit ID number “3”.