E-RAE Electronics Industry Co Ltd DLN-30D3 用户手册
4 3
Trouble shooting Tips
Maintenance and Service
Problem
Action
Remote controller does not work.
1. Check if main power is on.
2. Check that the batteries of the remote controller were
2. Check that the batteries of the remote controller were
loaded properly.
3. Check to see if any obstacle exists between the LCD
TV and the remote controller and remove it, if any.
4. If the batteries have no power, replace them with two
new batteries.
LCD TV makes strange noise.
It is the noise when the mechanism expands or contracts
from to changes to the environment due to factors such
as humidity, temperature, etc. It is not a failure.
from to changes to the environment due to factors such
as humidity, temperature, etc. It is not a failure.
LCD TV indication lamp is on.
The red means the Stand-by power is on. It will take a few
seconds to turn off as the main power is off.
seconds to turn off as the main power is off.
Had forgotten Password of V-Chip
Press
,
,
,
,
buttons on the Remotecontrol
in V-Chip function.
Can not select PC mode when D-sub
D-sub cable must not meet VESA standard. (D-sub No. 10
cable is connected to the RGB output
pin must be grounded) Component cable can be used if
of Set-top-box.
there is an Component terminal.(See Page 18)
This LCD TV is for household use and registered as suitable on electromagnetic waves.
Therefore, you can use it in every location as well as residential areas.
Therefore, you can use it in every location as well as residential areas.
●
Others
If any signal of unsupported resolution is input, the "Out of Range" message appears.
●
Considerations in Installation
●
Supporting display mode
Resolution
Horizontal Frequency (KHz)
Vertical Frequency (Hz)
31.47
60
37.86
72
37.50
75
31.47
70
35.15
56
48.88
72
46.88
75
48.36
60
56.48
70
60.02
75
64.0
60
640
×
480
720
×
400
800
×
600
1024
×
768
1280
×
1024