Wavenet Technology Pty Ltd. DWM0001 用户手册

Dualwave M User Manual ___________________________________________________________ Getting Started

13

Wavenet Technology

If the indicators on the battery charger are flashing red, indicating a
fault, return the battery charger and Dualwave M to your vendor for
servicing.

When the batteries are fully charged, the battery charger stops charging
until the batteries’ capacity falls below a certain value. The battery
charger will then automatically start recharging the batteries again.

For optimum battery performance it is recommended that the battery
charger is disconnected and reconnected from the power source to start
the charge cycle from the beginning.

Warning : For safety reasons, only use the battery charger supplied
with the Dualwave M.

To install the Modem Tools software onto your PDA, ensure that the
PDA desktop software has been installed first and then use the
following procedure:

1.  Attach the Dualwave M to your PDA, as described previously.

2.  Carefully push the Data Comms Modem connector squarely

into the Dualwave M’s Data Interface port. This is located at
the front of the Dualwave M.

Caution: The Data Comms Modem Connector has a latch to
secure the connector to the Dualwave M. Before removing the
Data Comms Modem connector from the Dualwave M, press
the release button on the underside of the connector to
disengage the latch.

3.  Connect the Data Comms PC serial connector to a COM (serial)

port on your computer. Note that the Data Comms PC serial

Data Comms PC serial
connector (9-pin)

Data Comms Modem connector

Data Comms PC USB
connector (9-pin)

Release Button