Wistron Corporation 72XX 用户手册

User's manual NAVIGON 72XX 

Navigation 

- 21 - 

When you have reached your selected destination, a message to this 
effect will be displayed. 
Only your current position (orange arrow) will now be shown on the 
map. 

You have switched on the navigation device and, if necessary, entered 
the password. 
The following message displays: 
"The navigation software on this device is designed to provide route 
suggestions and does not replace the need for driver attentiveness or 
the requirement to adhere to road traffic regulations, good driving 
practice and legally posted directions.  For safety, posted road signs 
and directions should always take precedence over the directions of this 
unit.  Do not operate this unit while driving." 

► 

After you have read and fully understood the message, tap on OK. 
If you do accept the content of the message, tap on Cancel in order 
to switch off the navigation device. 

The N

 window is opened. From here you can access all the 

functions of the navigation application. 

► 

Tap on 

 (Phone) in order to move the hands-free module 

into the foreground. 

► 

Tap on 

 (Navigation) in order to move the N

 

window back into the foreground. 

As soon as the navigation device has been switched on, initialisation of 
the GPS receiver will begin. 
The integrated GPS receiver is not initialised for the first time until the 
navigation application is started for the first time. It can take up to 
20 minutes to initialise the GPS receiver for the first time. 

 

Note: If the GPS icon indicates GPS Ready after far less than 
20 minutes, it is advisable to leave the navigation device switched on 
for at least another 15 minutes in order to ensure reliable operation of 
the receiver. 

 

Each time you switch on the navigation device after this, GPS reception 
will start within a short time. 
If the navigation device has not been switched on for more than a week, 
it can take up to 10 minutes to re-initialise the receiver.