RadioFrame Networks Inc DH2 用户手册
RadioFrame System
Installation
RFN_3.1 Beta
79
cable with two male BNC connectors; one connector is a tee adapter
terminated on end of the tee—this end is connected to the iSC-3).
terminated on end of the tee—this end is connected to the iSC-3).
2 Lay the Ethernet Media Converter on any flat surface following these
guidelines:
•
Do not block the air vents on the sides of the Ethernet Media Converter.
•
Mount the Ethernet Media Converter so that both the front and back are
accessible.
accessible.
3 Plug the Ethernet Media Converter into an approved power source using the
provided power adapter (use of a different cord may void the warranty and/or
cause electrical fire and damage).
cause electrical fire and damage).
4 Set the Terminator switch on the front of the Ethernet Media Converter to
“On”, and set the MDI switch to “MDI-X” (see the following illustration).
5 Connect Port 1 on the front of the NCU to the 10BaseT port (RJ45) on the
Ethernet Media Converter using the provided straight-through CAT 5 cable.
6 Connect one of the three 10Base2 ports on the back of the iSC-3 (port to be
specified by the RFN customer) to the 10Base2 port on the Ethernet Media
Converter.
Converter.
Use only the provided 10Base2 cable: 50 ohm coaxial cable with two male
BNC connectors; the terminated tee adapter connector connects to the iSC-3
only.
BNC connectors; the terminated tee adapter connector connects to the iSC-3
only.
Figure 30
Connecting the RFS to an iSC-3 requires using an Ethernet Media
Converter.
Converter.