Wilson Electronics LLC 273201 用户手册
3
4
Contact Wilson Electronics’s Technical Support Team with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com Mon.- Fri. Hours: 7am to 6 pm MST.
Powering up a Wilson Electronics Signal Booster
Connect the power cable from the DC plug-in power
supply to the Signal Booster marked “6 V DC” and
insert the large end into DC power socket (the vehicle
power adapter outlet) .
The Signal Booster may remain on all the
time . However, leaving the Signal Booster
on in a vehicle when it is not running can
discharge or drain the battery in a day or
two . Switch the power supply off when not
in use .
A good option is to power the Signal
A good option is to power the Signal
Booster through the ignition switch so the
Signal Booster is turned on and off with the
vehicle .
An available option to do this with is the
An available option to do this with is the
Hardwire Kit from Wilson Electronics .
Part# 859923 .
IMPORTANT: Do not power up the Signal
Booster unless antenna cables are attached
to Signal Booster .
ON/OFF SWITCH
Understanding the Signal Booster Lights
The power light will turn green when the
Signal Booster is successfully powered up .
When the 800 MHz or 1900 MHz lights are
lit green, the Signal Booster is amplifying
the outside signal .
If one or both frequency lights turn red,
If one or both frequency lights turn red,
oscillation is occurring and the Signal
Booster has powered down on the
frequency with the red light to prevent
oscillation . The Outside Antenna needs to
be moved farther from the Inside Antenna .
Move the Outside Antenna on the roof of
the car to the rear of the car, but at least
8-12 inches from the rear or side windows .
Disconnect power from the Signal Booster
and reconnect power . This resets the
Signal Booster .
If the lights are now green, the Signal
If the lights are now green, the Signal
Booster is working properly . If the red light
is still on, move the antenna farther away
and repeat the process .
Always use a magnet-mount or roof-
Always use a magnet-mount or roof-
mount antenna . Do not use a glass-
mount antenna, as oscillation may cause
continuous shut-down of the Signal Booster .
All green lights
Red light on frequency indicator