Wilson Electronics LLC 2B1216 用户手册
AIG #111044_Rev02_02 .16 .12
3301 East Deseret Drive, St . George, UT 84790
For additional Technical Support visit www .WilsonElectronics .com
or email at: tech@wilsonelectronics .com
Phone: 866-294-1660 Local: 435-673-5021 Fax: 435-656-2432
www .twitter .com/WilsonCellular www .facebook .com/WilsonCellular
Signal Booster Specifications
Dual-Band
Model Number / Part Number
2B1216
Connectors
FME Female
Impedance (input/output)
50 ohms
Dimensions
6 .12 x 3 .5 x 2 .0
Frequency
824-894 MHz / 1850-1990 MHz
1
Passband Gain (nominal)
800 MHz
Typical / Maximum
1900 MHz
Typical / Maximum
Uplink
11 dB / 13 dB
11 dB / 13 dB
Downlink
11 dB / 13 dB
13 dB / 15 dB
2
20 dB Bandwidth (nominal)
800 MHz
Typical / Maximum
1900 MHz
Typical / Maximum
Uplink
44 MHz / 48 MHz
76 MHz / 84 MHz
Downlink
45 MHz / 50 MHz
87 MHz / 96 MHz
3
Power output for single cell phone (uplink) dBm
800 MHz
1900 MHz
EDGE
36 .2
35 .0
GSM
35 .8
34 .4
CDMA
34 .7
33 .8
WCDMA
35 .1
33 .7
4
Power output for multiple received
channels (uplink) dBm. The
maximum power is reduced by the
number of channels:
Number of
channels
Maximum Power
3
800 MHz
1900 MHz
2
22 .1
29 .6
3
18 .6
26 .1
4
16 .1
23 .6
5
14 .2
21 .6
6
12 .6
20 .0
Noise Figure (typical)
3 dB nominal
Isolation
> 30 dB
Power Requirements
7V DC, 3A
Notes:
1 . Nominal gain is the maximum gain at any frequency in the passband .
2 . Nominal bandwidth is the difference between two frequencies that are adjacent to the passband where the amplification is 20 dB
lower than the passband amplification . One of the frequencies is lower than the passband and the other is higher .
3 . The Manufacturer’s rated output power of this equipment is for single carrier operation . For situations when multiple carrier
signals are present, the rating would have to be reduced by 3 .5 dB, especially where the output signal is re-radiated and can
cause interference to adjacent band users . This power reduction is to be by means of input power or gain reduction and not by an
attenuator at the output of the device .
4 . The maximum power for 2 or more simultaneous signals will be reduced by 6 dB every time the number of signals is doubled .