RFNet Technologies Pte Ltd AP2061 用户手册

 

Pg 5 of 26 

Radio signals drop in power over a distance. Even if all the settings are correct, low signal 

strength makes association impossible.  The usable distance between the AP and client can 
range from a few meters indoor to a few km. When setting up the client, make sure that you: 

 

 

Keep at a distance between the AP and the clients. 

 

Make sure that the WLAN signals do not have to pass through too many 
concrete walls and metal structures to reach the client. 

 

Make sure that clients are located far away from one another to avoid 
interference. 

 

Make sure that there is line of sight between the AP and client device.

 

Interference happens when 2 clients with the same channels are placed near to one another. 

The speed of the network drops and the signal strength fluctuates wildly. 

Association happens when the SSID, Encryption and MAC Address Control settings 
are correct between the AP and client. If 2 APs with these same settings are located 
in the same area, the client would choose to associate to the one which gives it a 
better signal strength. The client would roam over to the 2nd AP when he moves 
nearer to it. The client switches AP and frequency as he does so.

 

Connect the network as shown previously. 

 

 
 

 

If your PC is wireless, check the PC’s card utility to make sure that the 
signal strength is good. 

 

Open a Web browser (Internet Explorer, Netscape etc.). 

Type the AP LAN IP (192.168.1.20) address into the browser’s Address field. The default LAN 
IP address is 192.168.1.20. 

 

Note: If you have changed the default IP of the AP, make sure you enter the correct IP 

address.