Netgear 06100038 用户手册

1)  The antenna must be installed such that 20 cm is maintained between the 

antenna and users, and   

2)  The transmitter module may not be co-located with any other transmitter or 

antenna. 

As long as 2 conditions above are met, further transmitter test will not be required. 

However, the OEM integrator is still responsible for testing their end-product for any 

additional compliance requirements required with this module installed (for example, 

digital device emissions, PC peripheral requirements, etc.). 

 

IMPORTANT NOTE: In the event that these conditions can not be met (for example 

certain laptop configurations or co-location with another transmitter), then the FCC 

authorization is no longer considered valid and the FCC ID can not be used on the 

final product. In these circumstances, the OEM integrator will be responsible for 

re-evaluating the end product (including the transmitter) and obtaining a separate 

FCC authorization. 

 

This transmitter module is authorized only for use in device where the antenna may 

be installed such that 20 cm may be maintained between the antenna and users (for 

example: Access point, Router…etc). The final end product must be labeled in a 

visible area with the following: “Contains TX FCC ID: PY306100038”. 

 

The OEM integrator has to be aware not to provide information to the end user 

regarding how to install or remove this RF module in the users manual of the end 

product which integrate this module. 

 

The users manual for OEM integrators must include the following information in a 

prominent location “ IMPORTANT NOTE: To comply with FCC RF exposure 

compliance requirements, the antenna used for this transmitter must be installed to 

provide a separation distance of at least 20 cm from all persons and must not be 

co-located or operating in conjunction with any other antenna or transmitter.