Netgear 09300118 用户手册

1-10

Installation and Basic Configuration

You can use the security button to change the default encryption key and set a private encryption 
key instead. The default encryption key is HomePlugAV.

1. Verify that all the Powerline AV 200 Wireless-N Extenders to be configured are plugged in. 

2. On the first Powerline AV 200 Wireless-N Extender, press its security button for 2 seconds. 

The power LED will start blinking after you release the button.

The adapter will automatically produce a new, randomly generated network encryption key 
that each Powerline AV 200 Wireless-N Extender will use. 

At this point, the other adapters in your network cannot communicate with each other.

3. Within 2 minutes of pushing the security button on the first adapter, push the security button 

on the second adapter for 2 seconds.

In order to pair the devices, both buttons must be pushed within 2 minutes.

This securely configures your Powerline network with the same network encryption key.

4. If your network has more than 2 adapters, push the security button on the additional adapter 

for 2 seconds, then push the security button on any additional adapters in your existing 
network for 2 seconds. Both buttons must be pushed within 2 minutes. The adapters retain 
security settings even if they are unplugged. 

Warning: Do not press the Security button on the Powerline adapter until 

installation is complete and all adapters on your network are plugged in 
and communicating with each other. Pressing the Security button too 
soon can temporarily disable Powerline communication. If this should 
occur, reset the Powerline adapter to its factory default settings. See 

Note: An adapter can only generate a private key once. To replace a private key, 

first reset the adapter back to its factory defaults, then follow the procedure 
above. See 

.