Netgear 09400126 用户手册

2-12

Wireless Configuration

You can add more WPS clients to your wireless network, or you can add a combination of WPS-
enabled clients and clients without WPS.

To add a wireless client device that is WPS-enabled, follow the procedures in 

 or 

For non-WPS clients, you cannot use the WPS setup procedures to add them to the wireless 
network. You must record, and then manually enter your security settings (see 

).

To connect a combination of non-WPS enabled and WPS-Enabled clients to the gateway:

1. Restore the gateway to its factory default settings (press the Restore Factory Settings button on 

the rear panel of the gateway for 5 seconds).

When the factory settings are restored, all existing wireless clients are disassociated and 
disconnected from the gateway.

2. Configure the network name (SSID), select the WPA/PSK [TKIP] + WPA2/PSK[AES] radio 

button on the Wireless Settings screen (see 

). and click Apply. On the WPA/PSK + WPA2/PSK screen, select a 

passphrase and click Apply. Record this information to add additional clients.

3. For the non-WPS devices that you want to connect, open the networking utility and follow the 

utility’s instructions to enter the security settings that you selected in Step 2 (the SSID, WPA/
PSK + WPA2/PSK security method, and passphrase).

4. For the WPS devices that you want to connect, follow the procedure 

.

Note: If no WPS-capable client devices are located during the 2-minute timeframe, the 

SSID will not be changed and no security will be implemented on the gateway.