Netgear 11300176 用户手册

B.   

Notification of Compliance

Actual data throughput will vary. Network conditions and environmental factors, including volume of network traffic, 
building materials and construction, and network overhead, lower actual data throughput rate.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed 
and used in accordance with the instructions, may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off and on, the user 
is encouraged to try to correct the interference by one of the following measures:

Reorient or relocate the receiving antenna 

Increase the separation between the equipment and the receiver. 

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modification not expressly approved by the party responsible for compliance could 
void the user’s authority to operate the equipment.

Operations in the 5.15-5.25 GHz band are restricted to indoor usage only.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This 
device may not cause harmful interference, and (2) this device must accept any interference received, including 
interference that may cause undesired operation.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

The product complies with the FCC portable RF exposure limit set forth for an uncontrolled environment and is safe 
for intended operation as described in this manual. The further RF exposure reduction can be achieved if the 
product can be kept as far as possible from the user’s body or if the device can be set to a lower output power if 
such function is available.

The USB dongle transmitter is approved for use in typical laptop computers. To comply with FCC RF exposure 
requirements, it should not be used in other devices or certain laptop and tablet computer configurations where the 
USB connectors on the host computer are unable to provide or ensure the necessary operating configurations 
intended for the device and its users or bystanders to satisfy RF exposure compliance requirements.

Note: The country code selection is for non-US models only and is not available to all US models. Per FCC 
regulation, all Wi-Fi products marketed in the US must be fixed to US operation channels only.