Netgear 11300177 用户手册
Chapter 6. Advanced Settings
|
83
NETGEAR N300 Wireless Gigabit Router with USB JNR3210 User Manual
2.
Log into the router base unit, under the Advanced heading, select Wireless Repeating
Function to display the Wireless Repeating Function screen.
Function to display the Wireless Repeating Function screen.
3.
Select the Enable Wireless Repeating Function check box and the Wireless Base
Station radio button.
Station radio button.
4.
Enter the MAC address for the repeater units.
5.
Click Apply to save your changes.
Set Up a Repeater Unit
Use a wired Ethernet connection to set up the repeater unit to avoid conflicts with the
wireless connection to the base station.
wireless connection to the base station.
Note:
If you are using the JNR3210 base station with a non-NETGEAR
router as the repeater, you might need to change additional
configuration settings. In particular, you should disable the DHCP
server function on the wireless repeater
configuration settings. In particular, you should disable the DHCP
server function on the wireless repeater
access point.
To configure a JNR3210 router as a repeater unit:
1.
If you are using the same model of router for both the base station and repeaters, you
must change the LAN IP address for each repeater to a different IP address in the same
subnet (see
must change the LAN IP address for each repeater to a different IP address in the same
subnet (see
67).
Note:
Failing to change the LAN IP address will cause an IP address
conflict in the network because the factory default LAN IP is the
same for both units.
same for both units.