Netgear 11300177 用户手册

Restore the Default Configuration and Password

This section explains how to restore the factory default configuration settings that reset the 
router’s user name to admin, the password to password, and the IP address to 192.168.1.1.

You can erase the current configuration and restore factory defaults in two ways:

57.

Use the restore factory settings button on the rear panel of the router. Use this method for 

cases when the administration password or IP address is not known.

Locate the restore factory settings button on the rear panel of the router.

Use a sharp object such as a pen or a paper clip to press and hold the restore factory 
settings button for about 5 seconds, until the Power/Check LED begins to blink.

Release the restore factory settings button, and wait for the router to restart, and for the 
Power/Check LED to stop blinking and become solid green.

The factory default settings will be restored so that you can access the router from your 
Web browser using the factory defaults.

If the router fails to restart, or the Power/Check LED continues to blink or turns solid amber, 
the unit might be defective. If the error persists, you might have a hardware problem and 
should contact Technical Support at 

.