Netgear 12300211 用户手册
Virtual Private Networking
116
N300 Wireless ADSL2+ Modem Router DGN2200v4
Set Up a Gateway-to-Gateway VPN Configuration
This section describes how to use the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
default parameters listed in
105. If you have special requirements not
124 for information about how to set up the VPN tunnel.
Follow this procedure to configure a gateway-to-gateway VPN tunnel using the VPN Wizard.
Gateway A
Gateway B
VPN tunnel
22.23.24.25
14.15.16.17
IP: 192.168.0.1
IP:192.168.3.1
Figure 13. Gateway-to-gateway VPN tunnel
Set the LAN IPs on each modem router to a different subnet and configure each correctly for
the Internet. The subsequent examples assume the settings shown in the following table.
the Internet. The subsequent examples assume the settings shown in the following table.
Table 7. Gateway-to-Gateway VPN Tunnel Configuration Worksheet
Parameter
Value to Be Entered Field Selection
Connection Name
GtoGr
N/A
Pre-Shared Key
12345678
N/A
Secure Association
N/A
Main Mode
Manual Keys
Perfect Forward secrecy
N/A
Enabled
Disabled
Encryption Protocol
N/A
DES
3DES
Authentication Protocol
N/A
MD5
SHA-1
Diffie-Hellman (DH) Group
N/A
Group 1
Group 2
Key Life in seconds
28800 (8 hours)
N/A
IKE Life Time in seconds
3600 (1 hour)
N/A
VPN Endpoint
Local IPSecID
LAN IP Address
Subnet Mask
FQDN or Gateway
IP (WAN IP
IP (WAN IP
Address)