Netgear 13200235 用户手册
Set up a Virtual Private Network (VPN)
103
Configure a Windows Computer as a Remote Client
This example describes how to use NETGEAR ProSAFE VPN client software to set up a VPN
client for the gateway.
client for the gateway.
To use NETGEAR ProSAFE to set up a VPN client:
Download the trial version of NETGEAR ProSAFE VPN client (VPNG01L/VPNG05L
Professional Software Version 5.14.003) and install it on the Windows computer.
Professional Software Version 5.14.003) and install it on the Windows computer.
1. This software is available here:
http://kb.netgear.com/app/answers/detail/a_id/20316
.
2. Launch the VPN client software.
3. In the left pane, select Global Parameters.
4. Specify the following settings:
Lifetime
(sec):
• Authentication (IKE): Enter 3600, 360, 28800.
• Encryption (IPSec): Enter 3600, 300, 28800.
Dead Peer Detection (DPD):
• Check interval: Enter 30.
• Max. number of retries: Enter 5.
• Delay between retries: Enter 15.
Miscellaneous:
• Retransmissions:
Enter
2
.
• X-Auth timeout: Enter 60.
5. In the left pane, select Gateway, and click the Authentication tab.
6. In the Authentication screen, specify these settings:
In the Addresses section, specify the following:
• In
the
Remote Gateway
field, enter the WAN IP address.
• Select
the
Pre-Shared Key
radio button and enter the same key that is
configured on the gateway.
In the IKE section, specify the following:
• Encryption:
Select
3DES
.