Primex Wireless Inc. SNSP 用户手册

下载
页码 10
SNS™ Personal Clocks User Guide 
Page 5 
SNS Personal Series Clocks 
Precautions and regulatory compliance statements 
This section contains mandatory precautions and regulatory compliance statements. 
Safety precautions 
SNS Personal Series Clocks are designed for indoor use only and are not weather protected. Operating 
the clock outdoors, or in wet areas is an electrical hazard and may damage the clock while nullifying the 
warranty. 
Equipment precautions 
• 
To avoid possible electric shock and damage to an SNS Personal Series Clock, make sure that the 
batteries are removed when working on it. 
• 
For healthcare facilities, clocks are not intended for patient use and must not be installed within 6ft 
(2m) of patient contact. 
• 
SNS Personal Series Clocks can be cleaned with a cloth moistened with water or a common 
disinfectant. 
Caution
  Be sure to test any cleaning solutions on a small area of the clock before using it on the 
entire clock. 
FCC compliance 
Any changes or modifications not expressly approved by the party responsible for compliance could 
void the user's authority to operate the equipment. 
FCC radio frequency interference 
This equipment has been tested and found to comply with the limits for a Class B analog device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications. However, there is no guarantee that interference 
will not occur in a particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following measures: 
• 
Reorient or relocate the receiving antenna. 
• 
Increase the distance between the equipment and the receiver. 
• 
Connect the equipment to an outlet on a circuit different from that to which the receiver is 
connected. 
• 
Consult the dealer or an experienced radio/TV technician for help. 
FCC radiation exposure limits 
To comply with FCC RF exposure requirements in section 1.1307, a minimum separation distance of 
20 cm is required between the antenna and all persons.