Radwin Ltd. 5XACMOD3C 用户手册
FinM Deployment Guide
Release 4.5.10
4‐1
Chapter 4: Configuring the
Radio Network
Radio Network
4.1 Scope of This Chapter
This chapter shows how to work with the Configurator Application, and provides a few
examples of some parameters. It also includes some tips and advice for best practices when
working with the Configurator.
examples of some parameters. It also includes some tips and advice for best practices when
working with the Configurator.
4.2 Connecting to the Units
For a first time configuration, all units are set to an IP address of 10.0.0.120 with subnet mask
255.0.0.0. The laptop Ethernet card should be set to a free IP address on that subnet (for
example 10.0.0.111).
255.0.0.0. The laptop Ethernet card should be set to a free IP address on that subnet (for
example 10.0.0.111).
All of the TBSs and any ISUs needed must be physically installed before you can work with the
Configurator.
Configurator.
4.3 About the Configurator Tool
The Configurator Tool is used to configure each active device used in your project: TMUs,
TBSs, and ISUs. You also use the Configurator Tool to set many general parameters including
IP address details, gateways, frequencies and bandwidths, and much more.
TBSs, and ISUs. You also use the Configurator Tool to set many general parameters including
IP address details, gateways, frequencies and bandwidths, and much more.
ISUs are required only in an environment that does not have access to a GPS signal
(tunnels, stations, etc.)
(tunnels, stations, etc.)
To use the Configurator Tool you must have MS Excel 2007 or later installed on
your laptop(s).
your laptop(s).