Radwin Ltd. BFJET5X 用户手册
RADWIN 5000 Installation Guide
Release 4.9.30
1‐5
Method of Work
Introduction
1.3.4 Method of Work
Both the base stations and the subscriber units communicate respectively, with the service
provider and users through PoE devices. The communication protocol for both the service
provider and the users is Ethernet.
provider and users through PoE devices. The communication protocol for both the service
provider and the users is Ethernet.
See
figure 1‐12, RADWIN 5000 Connection Scheme
:
•
) is connected to power and the communications network:
• On the base station side, the PoE is connected to the backhaul network
• On the subscriber unit side, the PoE is connected to end‐user equipment: routers,
WiFi devices, etc.
• The RADWIN JET DUO can have traffic and management via either its PoE port, or
its SFP data port, but must still receive voltage via a PoE.
•
Using CAT‐5e cables, the radio units are connected to power and the communications
network via a Power‐over‐Ethernet (PoE) device.
•
The radio units and PoE devices are also connected to ground.
•
The Base Station communicates with the Subscriber Unit or Units via the air interface.
Figure 1‐12: RADWIN 5000 Connection Scheme
1. The IDU‐H does not support beam‐forming radios: JET or DUO
For simplicity, Lightning Protection Units (LPU) are not shown in
Figure 1‐12
, but
these are recommended. See “Mounting the Lightning Protection Units” on page
2‐27 for directions on how to install the LPUs.
2‐27 for directions on how to install the LPUs.