Radwin Ltd. JETDB5X3X 用户手册
RADWIN 5000 Installation Guide
Release 4.9.30
2‐10
Vertical Pole
Installation Steps
Medium Pole
1. Diameter 2 to 3: Position the pole clamp as shown in the following figures. Do not tighten
the bolts all the way.
2. Place this “unit” on the pole where you want to mount the device. Once it is in
place, rotate the pole clamp as shown, then tighten both bolts.
Thick Pole
1. Diameter larger than 3: Use worm drive clamps (not supplied), threaded through the holes
as shown:
Figure 2‐16: Mounting kit on a thick pole
The pole clamp is not needed.
Figure 2‐12: Connect Pole Clamp to Radio
Holder
Holder
Figure 2‐13: Tighten bolts
Figure 2‐14: Rotate Clamp
Figure 2‐15: Completely tighten bolts
FOR REGULATORY APPROVAL ONLY