Radwin Ltd. RW2054 用户手册

RADWIN 1000/2000/5000 User ManualVersion  2.5.30p4

7-16

Use the following table to troubleshoot LED fault indications:

Use the following table to troubleshoot faults in the system:.

Prior to any action ensure that both ODUs have the same software version. 
You can see this on the inventory panels for each site.

For Site A, click Site A | Inventory and note the ODU software version. 
Repeat this for Site B using Site B | Inventory.

If either ODU has an old software version, perform a software upgrade. It is 
important to configure the new ODU exactly the same as the old ODU to 
avoid configuration mismatches, which will disrupt the link.

An ODU may be reconfigured in several ways. 

If a backup of the configuration is available, restore that configura-
tion using Site A| Restore.

Table 7-7: LED fault indicators

PWR

Off

Check that AC adapter is connected to the IDU-E and the AC 

power outlet.

IDU

Orange

Check that the IDU/ODU cable is properly wired and connected.

ODU

Red

Check that the IDU/ODU cable is properly wired and connected.

AIR I/F

Orange

Complete the installation procedure from the management soft-

ware.

Red

Check the ODU Antenna alignment. Check that the radio configu-

ration of both site A and site B units are the same (channel and 

Link ID).

SVC

Off

Table 7-8: Troubleshooting

No power

Ensure that power is connected to the IDU.

Ensure that the ODU cable is properly wired and connected.

No signal

Complete the installation procedure from the RADWIN Manager

Check the ODU alignment. Check that the radio configuration of both site A 

and site B units are the same (channel and Link ID.

Weak signal 

received

Check the ODU alignment, reconfigure the link.

Check the alignment tone sounds the Best Signal sequence.