Radwin Ltd. RW2054 用户手册

RADWIN 1000/2000/5000 User ManualVersion 2.5.30p4

3-1

This chapter sets out the requirements and procedures for the hardware 
installation and alignment of a RADWIN 1000/2000/5000 link in accordance 
with the prior planning as set out in chapter 

fied field technicians.

To protect against overexposure to RF energy, install the ODUs so as to pro-
vide and maintain minimal separation distances from all persons.

When the system is operational, avoid standing directly in front of the 
antenna. Strong RF fields are present when the transmitter is on. The ODU 
must not be deployed in a location where it is possible for people to stand 
or walk inadvertently in front of the antenna.

All RADWIN products should be grounded during operation. In addition:

• The ODU should be earthed by a wire with diameter of at least 

12AWG.
The RADWIN 1000/2000/5000 ODU must be properly grounded to 
protect against lightning. It is the user's responsibility to install the 
equipment in accordance with Section 810 of the National Electric 
Code, ANSI/NFPA No.70-1984 or Section 54 of the Canadian Electri-
cal Code. These codes describe correct installation procedures for 
grounding the outdoor unit, mast, lead-in wire and discharge unit. It 

Warning

Outdoor units and antennas should be installed ONLY by experienced 

installation professionals who are familiar with local building and safety 

codes and, wherever applicable, are licensed by the appropriate 

government regulatory authorities. Failure to do so may expose the end 

user or the service provider to legal and financial liabilities. RADWIN and its 

resellers or distributors are not liable for injury, damage or violation of 

regulations associated with the installation of outdoor units or antennas.