Radwin Ltd. RW2058U 用户手册

RADWIN 1000/2000/5000 User ManualVersion  2.5.30p3

3-13

, for connector pinouts.



• Connect a user switch, router or any other compatible device to the PoE 

device RJ-45 port designated LAN-IN. Refer to appendix 

You perform antenna alignment using the ODU's audible tone.

To speed up the installation time, alignment of a RADWIN 1000/2000/5000 
system should be performed by two teams simultaneously, at site A and at 
site B.



1. For external bipolar antennas: Using a coax cable with N-Type connec-

tors, connect the vertical polarization connector of the antenna to the 
ANT 1 connector of the ODU.

2. For external bipolar antennas: Using a coax cable with N-Type connec-

tors, connect the horizontal polarization connector of the antenna to the 
ANT 2 connector of the ODU.

3. Ensure that power is connected to the IDUs at both sites.

4. Ensure normal operation of the IDUs by the LED indications on the front 

panel.

Provided that site A detects the signal from site B, the ODU starts beep-
ing 20 seconds after power up, and continues beeping until the ODUs are 
aligned, and the installation is complete.

In the following steps, “antenna” refers both to an external antenna and 
an integrated antenna.

5. Direct the antenna of site B in the direction of site A. This is simplified if 

a previous site survey has been completed and azimuths are known.

6. Make a horizontal sweep of 180 degrees with the site A antenna so that 

the strongest signal from site B can be detected.

Do not connect two LAN ports to the same network, or flooding may occur.

When aligning the antennas, do not stand in front of a live antenna.