Radwin Ltd. WINLINK 用户手册
Chapter 2 Initial Setup
AirMux-104 Installation and Operation Manual
2-6
Performing Initial Setup of AirMux-104
Configuring Service Parameters
In the Service Parameters dialog box you can configure E1 and Ethernet
parameters. In addition, you can assign IP addresses of the local and remote
AirMux-104 units.
parameters. In addition, you can assign IP addresses of the local and remote
AirMux-104 units.
To configure E1 and Ethernet parameters:
1. In the General Parameters dialog box, perform the following steps:
1. In the General Parameters dialog box, perform the following steps:
Select the Ethernet Only check box, if you intend to transmit Ethernet data
only.
Select E1 service type, framed or unframed.
Framed E1 – assign timeslots to carry data.
You can assign all timeslots by clicking Select All, clear you selection by
clicking Clear All.
Timeslot 0 is reserved for framing information and cannot be selected to
carry user’s data.
You can assign all timeslots by clicking Select All, clear you selection by
clicking Clear All.
Timeslot 0 is reserved for framing information and cannot be selected to
carry user’s data.
Unframed E1 – all timeslots are assigned to carry data automatically.
When you assign timeslots to carry E1 data, AirMux-104 automatically calculates the
bandwidth remained for the Ethernet traffic. This value is displayed in the Data Rate
field at the right-hand corner of the Service Parameters dialog box (see
bandwidth remained for the Ethernet traffic. This value is displayed in the Data Rate
field at the right-hand corner of the Service Parameters dialog box (see
Enable CRC-4 bit generation, if required.
Click Next, if you do not intend to configure IP parameters of the
AirMux-104 units.
AirMux-104 units.
Figure 2-5. Service Parameters Dialog Box
Note