WatchGuard Technologies XP3E6W 用户手册

If you have a problem in your configuration file that you cannot correct, you can restore the factory default 
settings and start from a new configuration file. For example, if you do not know the administrator account 
passphrase, or if a power interruption causes damage to the Fireware XTM OS, you can restore the XTM 2-
Series device to the factory default settings and build your configuration again.

To set the XTM 2-Series device to the factory default settings:

1. Disconnect the power supply.

2. Hold down the Reset button on the back of the device.

3. Connect the power supply while you continue to hold down the Reset button.

4. Continue to hold down the button until the yellow Attn indicator stays lit. This shows that the device 

was successfully restored to the factory default settings. 

You must start the device again before you can connect to it. If you do not, when you try to connect to 
the device, a web page appears with the message, “Your device is running from a backup copy of 
firmware.” This message also appears if the Reset button is stuck in the depressed position. If you 
continue to see this message, check the Reset button and start the device again.

5. Disconnect the power supply.

6. Connect the power supply again.