Mobilicom ltd. MCU-30 用户手册
MCU-30 User Manual
Page : 48 / 51
This page contains information which is protected by copyright and is proprietary to Mobilicom Ltd.
No part of this document
may be used, copied, disclosed or conveyed to another party without prior written consent of Mobilicom Ltd
No link between MCUs
1.
Configuration isn’t the
same on all of the
MCUs.
same on all of the
MCUs.
2. PTP
– both MCUs set
as VC or both as
Node. MPTMP many
MCUs uses the same
ID.
Node. MPTMP many
MCUs uses the same
ID.
3.
The MCUs aren’t
within reception range
within reception range
1. Connect to each MCU and verify
they have the same configuration
(Frequency, profile, and
Transmission Vector (for MPTMP
only)
(Frequency, profile, and
Transmission Vector (for MPTMP
only)
2. PTP -Verify 1 unit is set as a VC and
the other as a Node. MPTMP - verify
each transmitting MCU have
different unit ID.
each transmitting MCU have
different unit ID.
3. Verify that TX power is set to the
maximum.
4. Verify the antennas fit the used
Frequency (antenna spec).
Data with high delay
and disconnecting data
and disconnecting data
Trying to send higher amount
of data than the allocated
bandwidth set to in the unit.
of data than the allocated
bandwidth set to in the unit.
1. Verify that the data bandwidth sent
to the unit from the connected
device(s) does not exceed the
allocated bandwidth (in its
configuration).
device(s) does not exceed the
allocated bandwidth (in its
configuration).
2. Decrease the data received by the
data source or change the allocated
bandwidth via MC-EMA
bandwidth via MC-EMA