Cardionet 1009 用户手册
Problem
Possible Solutions
Monitor
battery
power drains
quickly
Ensure battery is being fully recharged every day. A full recharge
takes approximately 4 hours and will last 16 hours.
Ensure the monitor is being placed in the base correctly. If the
Ensure the monitor is being placed in the base correctly. If the
monitor does not make contact with the plug in the base, it may
not recharge.
Monitor
screen is
blank
It could be that the monitor is not turned on.
Ensure the monitor is turned on by confirming that the LED light
Ensure the monitor is turned on by confirming that the LED light
is flashing red or green. If the monitor is asleep, press the blue
button. The screen should light up. If it doesn’t, the monitor may
be low on power. Return the monitor to the base for recharging.
Monitor
beeps while
you are in
bed
It is possible for your body to block communications between the
sensor and monitor. This will cause warning beeps. To avoid beeps
and maintain the communications link, place the sensor near the
monitor on the bed next to you. Try not to lie on top of it or to get
between the sensor and monitor while you are sleeping.
Your phone
line is busy
When the monitor is in the base station and sending information it
will use your telephone line. If someone calls you while the monitor
is using the line, they will get a busy signal. If you try to place a call
while the monitor is transmitting data, you will hear a high- pitched
sound. This is the sound of monitor data being transmitted.
Skin is
irritated or
reddened
If you notice that the skin under or around your electrode pads is
becoming sensitive, irritated or painful, or if you develop a rash,
please call the CardioNet Patient Service Center immediately at 1-
866-426-4401. Some people are sensitive or allergic to adhesives.
CardioNet will send you another type of electrode pad.
Sensor belt
clip is difficult
to put on
If you’re wearing a thicker belt and finding that it is difficult to
slide on the Sensor Belt Clip, first remove the CardioNet Sensor
from the clip. Slide just the clip onto your belt and then reposition
the sensor on the clip.
Troubleshooting
Troubleshooting
5
.
T
R
O
U
B
L
E
S
H
O
O
T
IN
G