Redline Communications Inc. AN100UA 用户手册
Red
MAX
™
Base Station
User Manual
Doc. #70-00058-01-01
Proprietary Redline Communications © 2007
July 13, 2007
Page 76 of 119
Chapter
5
5
5
C
C
L
L
I
I
I
I
n
n
t
t
e
e
r
r
f
f
a
a
c
c
e
e
The base station can be configured and monitored using the command line interface
(CLI) commands. This section describes the procedures for configuring and operating the
base station using the CLI over a Telnet connection.
(CLI) commands. This section describes the procedures for configuring and operating the
base station using the CLI over a Telnet connection.
5.1
Connecting via Telnet
To connect to the base station, open a Telnet session to the IP address of the base station
(default address is 192.168.101.3).
(default address is 192.168.101.3).
Figure 35: CLI - Connecting via Telnet
When the command prompt screen appears, login using the following (factory default) :
Username:
Username:
admin
Password:
admin
The base station may now be controlled using a set of CLI commands.
Telnet Logout
Exit from a CLI session by typing:
logout ENTER
The system will logout users automatically if no commands are received (idle) for five
minutes.
minutes.
5.2 CLI
Commands
The system defaults to root mode when you login to the base station. The following table
lists all base station specific commands available in root mode. All commands are case-
sensitive.
The following table lists commands available in the root directory. These commands are
described in detail in the following sections.
lists all base station specific commands available in root mode. All commands are case-
sensitive.
The following table lists commands available in the root directory. These commands are
described in detail in the following sections.