Redline Communications Inc. AN100UXA 用户手册
User
AN-100U/UX Base Station
Manual
70-00058-01-04
Proprietary Redline Communications © 2010
Page 61 of 136
April 19, 2010
High: Highest priority setting of range.
VlanID: Ethernet packet 802.1Q VLAN tag. Valid only if Cs Specification is 802.1Q.
Ip Prot.: IPv4 specification. Valid only if the service class Cs Specification is IPv4.
EnetProtocol: When displayed, classification is based on this Ethernet protocol.
Tos: Matching parameters for the IP type of service/DSCP (IETF RFC 2474). An IP type
of service (ToS) packet will match if the "ip-tos" value, after the mask is applied, is equal
to, or falls between, the high and low range setting. Valid settings are 0 to 255.
of service (ToS) packet will match if the "ip-tos" value, after the mask is applied, is equal
to, or falls between, the high and low range setting. Valid settings are 0 to 255.
Low: Lowest priority setting of range.
High: Highest priority setting of range.
Mask: A logical 'AND' is performed using the mask and the "ip-tos" value before
testing for range.
testing for range.
SrcIp: Source IPv4 address. Valid only if Cs Specification is IPv4.
Addr: Source IPv4 address network mask.
Mask: Source IPv4 address network mask.
DstIp: IPv4 destination address. Valid only if Cs Specification is IPv4.
Addr: Destination IPv4 address network mask.
Mask: Destination IPv4 address network mask.
DstIp: IPv4 destination address.
Addr Mask: Valid only if Cs Specification is IPv4.
SrcPort: Source IPv4 address port. Valid only if Cs Specification is IPv4.
Start: Lowest port address in range.
End: Highest port address in range.
DstPort: IPv4 destination port address. Valid only if Cs Specification is IPv4.
Start: Lowest port address in range.
End: Highest port address in range.