Redline Communications Inc. AN100UXA 用户手册
User
AN-100U/UX Base Station
Manual
70-00058-01-04
Proprietary Redline Communications © 2010
Page 92 of 136
April 19, 2010
Table 37: CLI - Interfaces Command: management
Command
Parameter/Description
1
Enable tagged management.
VlanId Enter the VLAN ID (VID) for the management VLAN.
default Restore all settings to factory default values.
default Restore all settings to factory default values.
show
Display the Ethernet management port configuration.
Example:
AN100U(mgmConfig ->)#> show
Structure --- <<Management Configuration>>
DHCP Relay Agent Params IP, ToD & VLAN params
------------------------------------- -------------------------------------
Enable:..............StaticIP(0) LocalIP:...........192.168.20.96
DhcpServIPUsr:.....192.168.20.52 LocalMask:.........255.255.255.0
Type:.......Use_DhcpServIpUsr(0) DefGateway:.......192.168.20.250
ToDIP:.............172.25.100.45
TimeZoneHour:.................-4
TimeZoneMinutes:...............0
DayLight Saving:......Enabled(1)
SysLogIP:..........192.168.20.73
Management VLAN:...........No(0)
VLAN ID:.......................0
AN100U(mgmConfig ->)#> show
Structure --- <<Management Configuration>>
DHCP Relay Agent Params IP, ToD & VLAN params
------------------------------------- -------------------------------------
Enable:..............StaticIP(0) LocalIP:...........192.168.20.96
DhcpServIPUsr:.....192.168.20.52 LocalMask:.........255.255.255.0
Type:.......Use_DhcpServIpUsr(0) DefGateway:.......192.168.20.250
ToDIP:.............172.25.100.45
TimeZoneHour:.................-4
TimeZoneMinutes:...............0
DayLight Saving:......Enabled(1)
SysLogIP:..........192.168.20.73
Management VLAN:...........No(0)
VLAN ID:.......................0
Table 38: CLI - Interfaces Command: wireless
Command
Parameter/Description
set
ChannelBandwidth
*
5 -- 7 Mhz
6 -- 3.5 Mhz;
CyclicPrefix
*
(phyCp)
0 -- 1/32
1 -- 1/16
2 -- 1/8
3 -- 1/4
Default restore all settings to factory default values.
DefaultUlSfEnable
DefaultUlSfEnable
*
0 -- disable default uplink service flows
1 -- enable default uplink service flows
Note: Default DL service flows are permanently enabled.
MacAdaptiveTDD
MacAdaptiveTDD
0 -- Disabled
1 -- Enable
MacAirInterfaceStatus
0 -- disable RF
1 -- enable RF
MacDLRatio
downlink ratio (25 - 80)
MacFrmDuration
0 -- 2.5
1 -- 4
2 -- 5
3 -- 8
4 -- 10
5 -- 12.5
6 -- 20
MacMaxDistance
*
maximum distance to any subscriber