Redline Communications Inc. AN80I 用户手册
Red
CONNEX
TM
AN-80i
PTP & PMP
User Manual
70-00072-01-04-DRAFT
Proprietary Redline Communications © 2007
May 7, 2007
Page 38 of 91
Chapter
4
4
4
P
P
M
M
P
P
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
4.1 Introduction
This section describes only the additional parameters required for configuring PMP
support, and an overview about defining and using VLAN and pass-through groups.
The AN-80i PMP software provides the following main features:
- IEEE 802.1Q standard compliance
- VLAN
support, and an overview about defining and using VLAN and pass-through groups.
The AN-80i PMP software provides the following main features:
- IEEE 802.1Q standard compliance
- VLAN
Groups
span subscribers
- Multiple
VLAN
Connections
per subscriber
- Multiple TLS transport based on VLAN ID classification
- QoS provisioning with individual CIR setting per connection
- VLAN trunking with tag insert/delete/re-map
- VLAN tagged management traffic
Notices: 1. DFS is not supported for PMP operation.
- QoS provisioning with individual CIR setting per connection
- VLAN trunking with tag insert/delete/re-map
- VLAN tagged management traffic
Notices: 1. DFS is not supported for PMP operation.
2. PMP operation is supported for the 5.8 GHz radio, and the 5.4 GHz radio
where DFS is not required by regional regulations.
where DFS is not required by regional regulations.
4.2 PMP
Menu
The following menu items are available for configuring and monitoring the PMP
functions. See Table 5: Web - Default System Users on page 30 for the factory default usernames and passwords.
functions. See Table 5: Web - Default System Users on page 30 for the factory default usernames and passwords.
Figure 19: PMP - Main Menu