Redline Communications Inc. AN80IA 用户手册
Red
CONNEX
TM
AN-80i
PMP
User Manual
70-00072-01-03
Proprietary Redline Communications © 2007
March 19, 2007
Page 13 of 60
2.5 Antenna
Alignment
The AN-80i includes an audible antenna alignment tool to assist in pointing the antenna
for maximum signal strength. The signal will sound infrequently when a low signal is
detected, and more often as the signal strength increases. The audible signal is enabled
and disabled through the user interface:
Web: see Antenna Alignment Buzzer Enable on page 24.
Telnet: see Antenna Alignment Buzzer Enable on page 41.
for maximum signal strength. The signal will sound infrequently when a low signal is
detected, and more often as the signal strength increases. The audible signal is enabled
and disabled through the user interface:
Web: see Antenna Alignment Buzzer Enable on page 24.
Telnet: see Antenna Alignment Buzzer Enable on page 41.
2.6
Indoor Power Block (PoE Power Adapter)
The PoE power adapter provides operational power and connection to a local Ethernet
network. The power block provides two Ethernet interfaces:
network. The power block provides two Ethernet interfaces:
INPUT: The 10/100Base-T Ethernet port (RJ-45) for connection to local network
equipment.
OUTPUT: The 10/100Base-T Ethernet port (RJ-45) port to carry signal and power to
the AN-80i.
equipment.
OUTPUT: The 10/100Base-T Ethernet port (RJ-45) port to carry signal and power to
the AN-80i.
Figure 3: Intro - Indoor Power-over-Ethernet (PoE) Module
Important: PoE Adapter Type
Use the AN-80i only with CINCON PoE Adapter Model TR60A-POE-L.
PoE Power Adapter Caution
Warning to Service Personnel: 48 VDC
Connecting customer premises Ethernet equipment directly to the 'OUTPUT'
connector on the AN-80i Power-over-Ethernet power adapter may damage
customer network interface equipment. Customer equipment including
personal computers, routers, etc., must only be connected to the 'INPUT' port
on the PoE unit. Only the outdoor Ethernet interface cable to the AN-80i can
be safely connected to the 'OUTPUT' connector.
connector on the AN-80i Power-over-Ethernet power adapter may damage
customer network interface equipment. Customer equipment including
personal computers, routers, etc., must only be connected to the 'INPUT' port
on the PoE unit. Only the outdoor Ethernet interface cable to the AN-80i can
be safely connected to the 'OUTPUT' connector.