Redline Communications Inc. AN80IC 用户手册
Red
CONNEX
™
User
AN-80i
Manual
70-00072-01-05-DRAFT
Proprietary Redline Communications © 2008
Page 63 of 94
January 22, 2008
Table 14: CLI - Root Mode Commands
PTP PMP Command Description
Tab
When entering a command, hit the Tab key at any time to perform
auto-complete or view available options.
auto-complete or view available options.
√
√
?
Use the '?' character to display help for any command or mode.
Example: From the root directory, enter the following command to
list all parameters that can be changed using the 'set' command:
set
Example: From the root directory, enter the following command to
list all parameters that can be changed using the 'set' command:
set
?
√
√
CTRL-Z
Return to root mode.
Cancel command entry (alternative to backspace delete).
Cancel command entry (alternative to backspace delete).
√
√
exit
Return to parent node / mode.
all (exit all) Return to root mode.
all (exit all) Return to root mode.
√
√
logout
Terminate this telnet session. May be entered from any mode.
5.2 Connecting
with
Telnet
To connect to the AN-80i, open a Telnet session to the IP address of the AN-80i. On a
Windows™ PC, open the Run command and type 'telnet' followed by the IP address of
the AN-80i. When the command prompt screen appears, login to the AN-80i. The AN-
80i may now be controlled using a set of CLI commands.
Windows™ PC, open the Run command and type 'telnet' followed by the IP address of
the AN-80i. When the command prompt screen appears, login to the AN-80i. The AN-
80i may now be controlled using a set of CLI commands.
Figure 35
: CLI - Connecting via Telnet
The system will logout users automatically if no commands are received (idle) for five
minutes. To exit immediately from the CLI, type the following command:
minutes. To exit immediately from the CLI, type the following command:
logout [ENTER]
5.3
CLI Command Set
5.3.1 Chgver
Use the chgver command to change the software version to loaded when you reboot the
AN-80i. Also see the Get command 'swver'.
AN-80i. Also see the Get command 'swver'.
Table 15: CLI - chgver
PTP PMP Parameter/Description
√
√
Enter this command to toggle between software versions. The setting will
alternate between the two banks of memory (no parameters).
alternate between the two banks of memory (no parameters).
chgver
<Enter>