Redline Communications Inc. AN80IE 用户手册
&
User
AN-80i
Manual
70-00072-01-07
Proprietary Redline Communications © 2010
Page 67 of 106
Sept 18, 2008
Table 20: CLI - Root Mode Commands
PT
P
PM
P
Comman
d
Description
√
√
Tab
When entering a command, hit the Tab key at any time to perform
auto-complete or view available options.
√
√
?
Use the '?' character to display help for any command or mode.
Example: From the root directory, enter the following command to
Example: From the root directory, enter the following command to
list all parameters that can be changed using the 'set' command:
set ?
√
√
CTRL-Z
Return to root mode.
Cancel command entry (alternative to backspace delete).
Cancel command entry (alternative to backspace delete).
√
√
exit
Return to parent node / mode.
all (exit all) Return to root mode.
all (exit all) Return to root mode.
√
√
logout
Terminate this telnet session. May be entered from any mode.
5.2
Connecting with Telnet
To connect to the AN-80i, open a Telnet session to the IP address of the AN-80i. On a
Windows™ PC, open the Run command and type 'telnet' followed by the IP address of
the AN-80i. When the command prompt screen appears, login to the AN-80i. The AN-80i
may now be controlled using a set of CLI commands.
Windows™ PC, open the Run command and type 'telnet' followed by the IP address of
the AN-80i. When the command prompt screen appears, login to the AN-80i. The AN-80i
may now be controlled using a set of CLI commands.
Figure 37: CLI - Connecting via Telnet
The system will logout users automatically if no commands are received (idle) for five
minutes. To exit immediately from the CLI, type the following command:
minutes. To exit immediately from the CLI, type the following command:
logout [ENTER]
The AN-80i supports two concurrent Telnet sessions. One session has full capabilities
and the second session is read-only (e.g., monitor or show parameter settings).
and the second session is read-only (e.g., monitor or show parameter settings).
5.3
CLI Command Set
5.3.1 Chgver
Use the chgver command to change the software version loaded when the AN-80i is
rebooted.
rebooted.
Table 21: CLI - chgver
PTP
PMP
Parameter/Description
√
√
Enter this command to toggle between software versions. The setting will
alternate between the two banks of memory (no parameters).
alternate between the two banks of memory (no parameters).
chgver <Enter>